- Measure bore, outside diameter, width and outer-ring profile — and note the forklift model.
- Replace rollers in sets to keep the mast aligned.
- Sealed, greased-for-life rollers extend service intervals in dusty warehouses.
Mast rollers are among the hardest-working bearings on a forklift. They guide the inner mast and fork carriage through every lift, absorbing shock loads when pallets are picked or dropped. Worn rollers cause noisy, jerky lifting and accelerate channel wear.
Types of forklift bearings
- Main mast rollers — run inside the mast channels (e.g. 180705K, 10310RT).
- Side rollers — control lateral play of the carriage.
- Chain sprocket / chain pulley bearings — carry the lift chains (e.g. 780708K).
- Composite support rollers — combined radial and axial rollers (e.g. PR4.058).
How to identify a mast roller
First look for the number stamped on the face or seal. If it is unreadable, measure: bore (d), outside diameter (D), width of inner and outer ring (they often differ), and the outer-ring profile — flat, crowned or with a flange. Note the forklift brand, model and capacity, and which position the roller came from.
Signs that rollers need replacing
- Flat spots, cracks or spalling on the outer ring.
- Radial play or rough rotation by hand.
- Noise or judder when lifting.
- Uneven, polished wear tracks in the mast channel.
Replacement tips
Replace rollers in matched sets and shim them to the manufacturer’s clearance so the mast stays square. Grease the channels where the OEM specifies it, and inspect the chains and sprockets at the same time.
Cross-reference and supply
We cross-reference mast rollers for Heli, Hangcha, TCM, Mitsubishi, Toyota and other forklifts and supply dealers with mixed shipments. Browse our forklift bearings or send a photo and measurements via the contact form.
Frequently asked questions
How long do forklift mast rollers last?
Service life depends on load, cycles and environment. Inspect them at every scheduled service and replace when play, noise or outer-ring damage appears.
Can you make rollers to sample?
Yes. Send a sample or drawing and we can produce mast rollers to the same dimensions and profile.




